Subaru Crosstrek Service Manual: Installation
LIGHTING SYSTEM > Auto Headlight Beam Leveler Control Module
INSTALLATION
CAUTION:
Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">
Install each part in the reverse order of removal.
Tightening torque:
Relay & fuse box: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
NOTE:
When the auto headlight beam leveler CM is removed, perform initialization or reinitialization. Auto Headlight Beam Leveler System > PROCEDURE">
Removal
LIGHTING SYSTEM > Auto Headlight Beam Leveler Control ModuleREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in &ldqu ...
Other materials:
Assembly
SEATS > Front SeatASSEMBLYCAUTION:• Do not confuse the harness routing of the side airbag harness and the seat belt inner - front harness, etc. Assembling with harnesses improperly routed may cause the harness to get caught and short out.• If the flat mat hook of the frame assembly - ...
Disassembly
DRIVE SHAFT SYSTEM > Rear Drive ShaftDISASSEMBLY1. Remove the outer race (DOJ) from the shaft assembly.CAUTION:Be careful not to damage the boot.(1) Using a flat tip screwdriver or pliers, loosen the boot band on the large end of boot (DOJ).CAUTION:Be careful not to damage the boot.(2) Remove the ...
Inspection
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > General DescriptionINSPECTION1. BASIC INSPECTIONBefore performing the diagnosis, check the following items which may cause problems relating the wiper or light.1. Check the battery. Battery">2. Check the relay and fuse condition. Relay ...
