Subaru Crosstrek Service Manual: Wiring diagram
LIGHTING SYSTEM > Back-up Light System
WIRING DIAGRAM
Refer to “Back-up Light System” in the wiring diagram. Back-up Light System > WIRING DIAGRAM">
Inspection
LIGHTING SYSTEM > Back-up Light SystemINSPECTION1. CHECK BACK-UP LIGHT SWITCH (MT MODEL)Refer to “INSPECTION” of the “Switches and Harness” in “MANUAL TRANSMISSION AND ...
Note
LIGHTING SYSTEM > Back-up Light SystemNOTEFor operation procedures of each component of the back-up light system, refer to the respective section.• Rear combination light assembly: Rear Comb ...
Other materials:
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Tumble Generator Valve ActuatorREMOVAL1. Disconnect the ground cable from battery.2. Disconnect the connector (A) from tumble generator valve assembly, and remove the tumble generator valve actuator.• RH side• LH side ...
Preparation for screen settings
1. Turn the ignition switch to the "ON"
position.
2. Push and hold the
button to show
the selection screen.
3. After the selection screen is displayed,
operate the "
" or "
" switch to show the
"Screen Setting" item. Then, push the
button. ...
Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Front Oxygen (A/F) SensorINSTALLATIONCAUTION:If lubricant is spilt over the exhaust pipe, wipe it off with cloth to avoid emission of smoke or causing a fire.1. Before installing front oxygen (A/F) sensor, apply anti-seize compound only to the threaded portio ...
