Subaru Crosstrek Service Manual: Inspection

1. CHECK BACK-UP LIGHT SWITCH (MT MODEL)

Refer to “INSPECTION” of the “Switches and Harness” in “MANUAL TRANSMISSION AND DIFFERENTIAL” section. Switches and Harness > INSPECTION">

2. CHECK INHIBITOR SWITCH (CVT MODEL)

Refer to “INSPECTION” of the “Inhibitor Switch” in “CONTINUOUSLY VARIABLE TRANSMISSION” section. Inhibitor Switch > INSPECTION">

Back-up light system

Wiring diagram

Other materials:

Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Primary Pulley and Secondary PulleyINSTALLATION1. Select shims for pulley alignment. Primary Pulley and Secondary Pulley > ADJUSTMENT">2. Install the seal ring to the input shaft.NOTE:• Use new seal rings.• When installing the se ...

Adjustment
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Idler GearADJUSTMENT1. Select the appropriate reverse shifter lever from the table below, and adjust until the clearance between the reverse idler gear and transmission case wall is within specification.Clearance A:6.0 — 7.5 mm (0.236 — 0.29 ...

32
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code32This DTC is detected out of vehicle speed range.Increase vehicle speed high enough to allow the cruise control to function, and then perform setting operation again.If cancel code is still detected after setting cruise a ...