Subaru Crosstrek Service Manual: Inspection
LIGHTING SYSTEM > High-mounted Stop Light
INSPECTION
1. Install the light to test if it illuminates normally.
2. If it fails to illuminate normally, replace the light assembly - high-mounted with a new part.
NOTE:
Since LED (Light Emitting Diode) is used for the light, replace the light assembly - high-mounted if the LED burns out.
Removal
LIGHTING SYSTEM > High-mounted Stop LightREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear gate UPR. Rear Gate Trim > REMOVAL& ...
Other materials:
General diagnostic table Inspection
CONTROL SYSTEMS > General Diagnostic TableINSPECTIONSymptomsPossible causeCorrective actionSelect leverStarter does not run.Adjust the select cable and inhibitor switch, or inspect the circuit.Back-up light does not illuminate.Adjust the select cable and inhibitor switch, or inspect the circuit.A ...
Language setting
1. Perform the preparation steps according
to "Preparation for screen settings"
2. Operate the "
" or "
" switch to
select the "Languages" item. Then push
the
button.
3. The current language setting will be
displayed. Push the
button to enter
the language s ...
Installation
COMMUNICATION SYSTEM > HornINSTALLATIONCAUTION:Install so that the front end of the under cover (b) comes inside the bumper face - front (a), and the front end of the mud guard (c) comes outside the bumper face - front (a).Install each part in the reverse order of removal.Tightening torque:Horn a ...
