Subaru Crosstrek Service Manual: Installation

Subaru Crosstrek Service Manual / Communication system / Horn / Installation

COMMUNICATION SYSTEM > Horn

INSTALLATION

CAUTION:

Install so that the front end of the under cover (b) comes inside the bumper face - front (a), and the front end of the mud guard (c) comes outside the bumper face - front (a).

Install each part in the reverse order of removal.

Tightening torque:

Horn assembly - Hi: 13 N·m (1.33 kgf-m, 9.6 ft-lb)

Horn assembly - Lo: 18 N·m (1.84 kgf-m, 13.3 ft-lb)

Removal

COMMUNICATION SYSTEM > HornREMOVALCAUTION:Do not remove the bumper face - front when removing the horn, in order to prevent damaging the claws of the bracket - front bumper corner and the bracket - ...

Horn switch

...

Other materials:

General description
Caution Blind Spot Detection/Rear Cross Traffic Alert > General DescriptionCAUTION• Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from battery. When replacing the electrical parts provided with memory functions that store contents specified by ...

Removal
LIGHTING SYSTEM > Ignition Switch IlluminationREMOVALNOTE:The ignition switch illumination is integrated into the immobilizer antenna assembly.1. Disconnect the ground cable from battery. NOTE">2. Remove the cover assembly - column.(1) Remove the screws by turning the steering wheel to r ...

Dtc b1826 open in side airbag lh
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1826 OPEN IN SIDE AIRBAG LHDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Side airbag harness (LH) circuit is open.• Side airbag module (LH) is faulty.• Airbag control modu ...