LIGHTING SYSTEM > Front Side Marker Light Bulb
INSPECTION
1. Visually check the bulb for blow out.
2. Check the bulb specification. General Description > SPECIFICATION">
3. Replace the bulb if it is found defective.
RemovalInspection
LIGHTING SYSTEM > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.NOTE:If the fuse is blown again, check the system wiring harness.2. CHECK RELAY1. Check the resistance between relay terminals.Terminal No.Inspection condit ...
Inspection
POWER ASSISTED SYSTEM (POWER STEERING) > Steering WheelINSPECTION1. PADDLE SHIFT SWITCHCheck the resistance of paddle switch.STEPCHECKYESNO1.SHIFT-UP SWITCH CONTINUITY CHECK.1) Operate the + side of paddle shift assembly and hold it.2) Measure the resistance between terminals of the paddle shift ...
Throttle position sensor Specification
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Throttle Position SensorSPECIFICATIONThrottle body is a non-disassembled part, so do not remove the throttle position sensor from throttle body.Refer to “Throttle Body” for removal and installation procedure. Throttle Body > REMOVAL"> ...