Subaru Crosstrek Service Manual: Inspection

1. HALOGEN TYPE

CAUTION:

• Do not perform work with wet hands, because there is a possibility of electrical shock.

• Do not leave the light assembly - head without the bulb and cover - headlight for a long time. Dust, moisture, etc. entering the headlight may affect its performance.

1. Visually check the bulb for blow out.

2. Check the bulb specification. General Description > SPECIFICATION">

3. Replace the bulb if it is found defective.

• Do not perform work with wet hands, because there is a possibility of electrical shock.

• Do not leave the light assembly - head without the bulb and cover - headlight for a long time. Dust, moisture, etc. entering the headlight may affect its performance.

• When lit (lighting switch is ON), do not touch the harness, light internals, or metal parts of the light.

• When performing a lighting test, make sure that the headlight is mounted on the vehicle, and the power supply is connected to the connector on the vehicle’s side.

1. Check the bulb specification. General Description > SPECIFICATION">

2. Install the factory HID bulb to check whether it lights properly.

3. If it does not light properly, replace with a new bulb.

4. Inspect the HID ballast.

Inspect the ballast in the following manner, and determine whether or not to reuse.

(1) Perform cold starts (light the headlight after turning off for 10 minutes or more), and hot starts (light the headlight for 15 minutes or more, then turn off for 1 minute and relight) several times, to make sure that the headlight lights properly.

(2) Monitor the lighting condition right after a cold start up to a stable state (approx. 5 min.), to see if there are any unstable conditions such as flickering.

(3) Install bulbs with the same number of operating hours on both headlights, and light for approximately 30 minutes. Check for whether there is a difference in brightness on the right and left sides.

5. Replace the ballast if it is found defective.

Headlight bulb

Removal

Other materials:

Dtc p060b internal control module a/d processing performance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P060B INTERNAL CONTROL MODULE A/D PROCESSING PERFORMANCENOTE:For the diagnostic procedure, refer to DTC P0606. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0606 CONTROL MODULE PROCESSOR&q ...

Ignition switch (models without "keyless access with push-button start system")
WARNING Never turn the ignition switch to the "LOCK" position while the vehicle is being driven or towed because that will lock the steering wheel, preventing steering control. And when the engine is turned off, it takes a much greater effort than usual to steer. Before leaving t ...

How to cancel Surround View Monitor
In the Subaru Ascent, the Surround View Monitor can be deactivated in several intuitive ways, depending on driving conditions and driver preference. Manual cancellation You can manually exit the Surround View Monitor display in the Subaru Ascent using any of the following actions. Press th ...