Subaru Crosstrek Service Manual: Inspection
LIGHTING SYSTEM > Glove Box Light
INSPECTION
1. Install the light to test if it illuminates normally.
2. If it fails to illuminate normally, replace the light - pocket with a new part.
NOTE:
Since LED (Light Emitting Diode) is used for the light, replace the light - pocket if the LED burns out.
Glove box light
...
Removal
LIGHTING SYSTEM > Glove Box LightREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the pocket assembly.(1) Attach the protective tape (a) to the panel center LWR.(2) Remo ...
Other materials:
Dtc p2123 throttle/pedal position sensor/switch "d" circuit high
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2123 THROTTLE/PEDAL POSITION SENSOR/SWITCH "D" CIRCUIT HIGHDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Improper idling• Poor driving performanceCAUTION:Afte ...
Assembly
BRAKE > Master CylinderASSEMBLYCAUTION:When replacing the reservoir tank, adhere the label to the position shown in the figure. (C5 model)Preparation items:C5 modelPart No.: Label (25080GA010)(a)Label(b)Brake booster 1. Install the seal to the cylinder body assembly.2. Install the reservoir tank ...
Rear wiring harness and rear gate cord Location
WIRING SYSTEM > Rear Wiring Harness and Rear Gate CordLOCATIONConnectorConnecting toNo.PoleColorAreaNo.DescriptionR163C-4 Rear door switch RHR223C-2 Rear door switch LHR2510BlackC-2 Radar sensor LH (master)R266GrayC-5 Rear combination light RHR286GrayC-3 Rear combination light LHR293BlackD-2 Rear ...
