Press the unlock/disarm button to unlock the driver's door. An electronic chirp will sound twice and the hazard warning flashers will flash twice. To unlock all doors and the rear gate, briefly press the unlock/disarm button a second time within 5 seconds.
NOTE
If the interval between the first and second presses of the unlock/disarm button (for unlocking of all of the doors and the rear gate) is extremely short, the system may not respond.
Unlocking the rear gate
Press the rear gate unlock button to unlock the rear gate.
An electronic chirp will sound twice and the hazard warning flashers will flash twice.
Locking the doors
Vehicle finder functionDtc p2758 torque converter clutch pressure control solenoid control circuit stuck on
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2758 TORQUE CONVERTER CLUTCH PRESSURE CONTROL SOLENOID CONTROL CIRCUIT STUCK ONDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:The e ...
Installation
LIGHTING SYSTEM > Front Fog Light BulbINSTALLATIONCAUTION:• After connecting the connector, make sure that the bulb is locked securely.• Install the mud guard - front so that the front end of the mud guard (b) comes outside the bumper face - front (a).Install each part in the reverse ...
Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Switches and HarnessINSTALLATION1. BACK-UP LIGHT AND NEUTRAL POSITION SWITCH1. Install the back-up light switch & neutral position switch with the harness.NOTE:Use a new gasket.Tightening torque:32.3 N·m (3.3 kgf-m, 23.8 ft-lb)(A)Neutral posi ...