Press the lock/arm button to lock all doors and rear gate. An electronic chirp will sound once and the hazard warning flashers will flash once.
If any of the doors (or the rear gate) is not fully closed, the following will occur to alert you that the doors (or the rear gate) are not properly closed.
When you close the door, it will automatically lock and then the following will occur.
Removal
SECURITY AND LOCKS > Keyless BuzzerREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle.3. Remove the clips and screws, and turn over the front side of the mud guard - front RH.4. Remove the keyless buzzer.(1) Disconnect the connector.(2) Remove the clip and d ...
Removal
MECHANICAL(H4DO) > Cam CarrierREMOVAL1. CAM CARRIER RH1. Remove the engine from the vehicle. Engine Assembly > REMOVAL">2. Remove the chain cover. Chain Cover > REMOVAL">3. Remove the timing chain RH. Timing Chain Assembly > REMOVAL">4. Remove the cam sprocket ...
32
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code32This DTC is detected out of vehicle speed range.Increase vehicle speed high enough to allow the cruise control to function, and then perform setting operation again.If cancel code is still detected after setting cruise a ...