Subaru Crosstrek Owners Manual: Installing child restraint systems with ALR/ELR seatbelt
WARNING
- Child restraint systems and seatbelts can become hot in a vehicle that has been closed up in sunny weather; they could burn a small child. Check the child restraint system before you place a child in it.
- Do not leave an unsecured child
restraint system in your vehicle.
Unsecured child restraint systems can be thrown around inside of the vehicle in a sudden stop, turn or accident; they can strike and injure vehicle occupants as well as result in serious injuries or death to the child.
CAUTION
- When you install a child restraint
system, follow the manufacturer's
instructions supplied with
it. After installing the child restraint
system, check to ensure
that it is held securely in position.
If it is not held tight and secure, the danger of your child suffering personal injury in the event of an accident may be increased.
- When installing a child restraint system in the rear center seating position, set both seatbacks to the original position. Otherwise, the child restraint system cannot be securely restrained, which may result in death or serious injuries in the event of sudden stop, sudden steering maneuver or an accident.
Choosing a child restraint system
Choose a child restraint system that is
appropriate for the child's age and size
(weight and height) in order to provide the
child with proper protection. The child
restraint system should mee ...
Installing a rearward facing child restraint
1. Place the child restraint system in the
rear seating position.
2. Run the lap and shoulder belt through
or around the child restraint system
following the instructions provided by its
ma ...
Other materials:
Stopping engine
Stop the vehicle completely.
Move the select lever to the "P"
position.
Press the push-button ignition switch.
The engine will stop, and the power will be
switched off.
WARNING
Do not touch the push-button
ignition switch during driving.
When the push-button ignition
switch is ...
Dtc b278d id code box judgment circuit
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B278D ID CODE BOX JUDGMENT CIRCUITDTC detecting condition:• When ID code box setting is set to OFF, ID code box ON input is detected.• When ID code box setting is se ...
Disassembly
WIPER AND WASHER SYSTEMS > Wiper BladeDISASSEMBLY1. FRONTPull the side (a) of the wiper rubber stopper, and remove the rubber assembly - windshield wiper from the blade assembly - windshield wiper.2. REARSlightly pull the top of the rubber assembly - rear wiper from the stopper (a), and pull out ...
