
SRS airbag system warning light (type B)
A diagnostic system continually monitors the readiness of the SRS airbag system (including front seatbelt pretensioners) while the vehicle is being driven. The SRS airbag system warning light will show normal system operation by illuminating for approximately 6 seconds when the ignition switch is turned to the "ON" position.
The following components are monitored by the indicator:
Front sub sensor
Airbag control module (including impact sensor and rollover sensor)
Frontal airbag module
Knee airbag module (driver's side)
Side airbag sensor
Front door impact sensor
Side airbag module
Curtain airbag sensor
Curtain airbag module
Satellite safing sensor (under the rear center seat)
Seatbelt pretensioner
Lap belt pretensioner (front passenger's side)
Seatbelt buckle switch (front passenger's side)
Front passenger's occupant detection system sensor
Front passenger's occupant detection control module
Front passenger's frontal airbag ON and OFF indicator
All related wiring
WARNING
If the warning light exhibits any of the following conditions, there may be a malfunction in the seatbelt pretensioners and/or SRS airbag system.
Immediately take your vehicle to your nearest SUBARU dealer to have the system checked. Unless checked and properly repaired, the seatbelt pretensioners and/or SRS airbag will not operate properly in the event of a collision, which may increase the risk of injury.
SRS side airbag and SRS curtain airbag
SRS airbag system servicingCheck engine warning light/Malfunction indicator light
CAUTION
If the CHECK ENGINE light illuminates
while you are driving, have
your vehicle checked/repaired by
your SUBARU dealer as soon as
possible. Continued vehicle operation
without having the emission
control system checked and repaired
as necessary could cause
serious damage, which may n ...
Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Driven GearINSTALLATION1. Install the taper roller bearing (transfer case side) outer race.(A)Taper roller bearing (transfer case side) outer race(B)Transfer case2. Apply a coat of grease to the taper roller bearing (transfer case side) of tran ...
Auto Vehicle Hold indicator light
CAUTION
If the Auto Vehicle Hold indicator light in your Subaru Ascent does not activate
after selecting "Auto Vehicle Hold (AVH)", this may indicate a potential issue with
the electronic parking brake system. In such cases, the system may not function
as intended, and it is recomme ...