Subaru Crosstrek Owners Manual: System servicing
WARNING
- When discarding a seatbelt retractor
assembly or scrapping
the entire vehicle damaged by a
collision, consult your SUBARU
dealer.
- Tampering with or disconnecting
the system's wiring could result
in accidental activation of the
seatbelt pretensioner and/or
SRS airbag or could make the
system inoperative, which may
result in serious injury. Do not
use electrical test equipment on
any circuit related to the seatbelt
pretensioner and SRS airbag
systems. For required servicing of the seatbelt pretensioner, consult
your nearest SUBARU dealer.
CAUTION
The sensors and SRS airbag control
module are located in the following
locations.
- Front sub sensors: on both the
right and left side at the front of
the vehicle
- Front door impact sensors: on
both front doors
- Satellite safing sensor: under the
rear center seat
- SRS airbag control module (including
the impact sensors and
rollover sensor): under the center
of the instrument panel
If you need service or repair in those
areas or near the front seatbelt
retractors, have the work performed
by your authorized SUBARU dealer.
NOTE
If the front or side part of the vehicle is
damaged in an accident to the extent
that the seatbelt pretensioner does not
operate, contact your SUBARU dealer
as soon as possible.
A diagnostic system continually monitors
the readiness of the seatbelt pretensioner
while the vehicle is being driven. The
seatbelt pretensioners share the control
module with the SRS airbag syste ...
Always consult your SUBARU dealer if
you want to install any accessory parts to
your vehicle.
CAUTION
Do not perform any of the following
modifications. Such modifications
can interfere with pro ...
Other materials:
Specifications
Dimensions
These specifications are subject to change without notice.
*: Measured with vehicle empty
Engine
Fuel
For more details, refer to "Fuel" F7-3. ...
Assembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Drive Pinion Shaft AssemblyASSEMBLY1. Install the sleeve and the gear and hub assembly by matching the alignment marks.NOTE:• Make sure that there is no large clearance at both sides of the 1st-2nd shifting insert after assembly.(A)1st-2nd shiftin ...
Screen Settings
After entering the "Screen Settings" menu,
select one of the following menus.
Welcome Good-bye Screen
The welcome screen/good-bye screens
can be activated or deactivated. Select
"On" to activate the screens. Select "Off"
to deactivate the screens.
Gauge Initial Movement
The movement of the m ...
© 2016-2024 Copyright www.sucross.com
![](data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAEALAAAAAABAAEAAAIBTAA7)