To turn the rear wiper on, turn the knob switch upward.
To turn the wiper off, return the knob
switch to the "
" position.
With the switch turned to the "
" position,
the rear wiper will operate intermittently
at intervals corresponding to the
vehicle speed. In this position, when you
move the select lever to the "R" position
(CVT models) or the shift lever to the
reverse position (MT models), the rear
wiper will switch to continuous operation.
When you move the select lever/shift lever from the "R" (reverse) position to another position, the rear wiper will return to intermittent operation.
Reverse gear interlocked rear wiper:
Even if the rear wiper switch is in the off
"
" position, if the front
windshield wiper is
operating continuously, the rear wiper will
operate intermittently when you move the
select lever/shift lever to the "R" (reverse)
position.
The factory setting (default setting) of the reverse gear interlocked rear wiper is as follows.
This setting can be changed by a SUBARU dealer. Consult your SUBARU dealer for details.
CAUTION
Do not attach anything that disturbs the rear wiper operation on the rear gate. Doing so may damage the rear wiper when it operates.
Rear window wiper and washer switch
WasherSeatbelt maintenance
To clean the seatbelts, use a mild soap
and lukewarm water. Never bleach or dye
the belts because this could seriously
affect their strength.
Inspect the seatbelts and attachments
including the webbing and all hardware
periodically for cracks, cuts, gashes,
tears, damage, loose bolts or wor ...
Dtc u0155 lost communication with instrument panel cluster (ipc) control module
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0155 LOST COMMUNICATION WITH INSTRUMENT PANEL CLUSTER (IPC) CONTROL MODULEDetected when CAN data from combination meter does not arrive.NOTE:Perform the diagnosis for LAN syst ...
Installation
AIRBAG SYSTEM > Side Airbag SensorINSTALLATIONCAUTION:Do not reuse the bolt and nut.Always replace with the specified new bolts and nuts.1. Before installation, inspect the following items and replace any faulty part with a new part.• The side airbag sensor, sensor bracket, or connector are ...