Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Inspection

WIPER AND WASHER SYSTEMS > Front Washer Nozzle and Hose

INSPECTION

Make sure the nozzle - windshield washer and the hose - windshield washer are not clogged.

Make sure the hose - windshield washer is not bent.

Check the position of the nozzle - windshield washer. Front Washer Nozzle and Hose > ADJUSTMENT">

Removal
WIPER AND WASHER SYSTEMS > Front Washer Nozzle and HoseREMOVAL1. NOZZLE - WINDSHIELD WASHER & HOSE1. Remove the arm assembly - windshield wiper. Front Wiper Arm > REMOVAL">2. Remove ...

Installation
WIPER AND WASHER SYSTEMS > Front Washer Nozzle and HoseINSTALLATIONCAUTION:Before installing the windshield glass and cowl panel, make sure there are no gravel in the installing area.1. Install the ...

Other materials:

Disassembly
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Drain SeparatorDISASSEMBLY1. Disconnect the drain tube (A) from the leak check valve assembly.NOTE:Disconnect the quick connector as shown in the figure.2. Lift up the claw (B) of the drain separator and slide the drain separator in the dir ...

Dtc p0617 starter relay "a" circuit high
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0617 STARTER RELAY "A" CIRCUIT HIGHDTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:Failure of engine to startCAUTION:After servicing or replacing faulty parts, perform Clear ...

Lock
The key can only be inserted or removed in this position. The ignition switch will lock the steering wheel when you remove the key. If turning the key is difficult, turn the steering wheel slightly to the right and left as you turn the key. The key can be turned from the "ACC" to "LOCK" ...

© 2016-2025 Copyright www.sucross.com