Subaru Crosstrek Service Manual: Installation
WIPER AND WASHER SYSTEMS > Front Washer Nozzle and Hose
INSTALLATION
CAUTION:
Before installing the windshield glass and cowl panel, make sure there are no gravel in the installing area.
1. Install the nozzle - windshield washer.
(1) Install the nozzle - windshield washer.
(2) Install the hose - windshield washer.
2. Install the cowl panel - side and the cowl panel assembly. Cowl Panel > INSTALLATION">
3. Install the arm assembly - windshield wiper. Front Wiper Arm > INSTALLATION">
4. Install the hose to the joint - washer hose. (Models with EyeSight)
5. Install the cover - joint to the cowl panel assembly. (Models with EyeSight)
6. Adjust the position of the nozzle - windshield washer. Front Washer Nozzle and Hose > ADJUSTMENT">
7. Operate the windshield wiper to check that the stop position is aligned with the point mark.
If it is not aligned with the point mark, perform the removal and installation of the windshield wiper over again. Front Wiper Arm > REMOVAL">
8. Make sure that there is a gap of 1 mm (0.04 in) or more between the hose and the cover joint and between the hose and the joint washer hose during windshield wiper operation. (Models with EyeSight)
(A) | Gap between hose and cover joint outer side | (C) | Gap between hose and cover joint inner side | (D) | Gap between hose and cover joint lower side |
(B) | Gap between hose and cover joint upper side |
Inspection
WIPER AND WASHER SYSTEMS > Front Washer Nozzle and HoseINSPECTION• Make sure the nozzle - windshield washer and the hose - windshield washer are not clogged.• Make sure the hose - winds ...
Front wiper arm
...
Other materials:
Electrical component location Location
AIRBAG SYSTEM (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)Front sub sensor (RH)(11)Side airbag sensor (RH)(20)Satellite safing sensor(2)Front sub sensor (LH)(12)Seat belt pretensioner (LH)(21)Occupant detection control module(3)Airbag control module(13)Seat belt pretensioner (RH)(22)B ...
24
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code24Malfunction in cruise control-related switch is detected.TROUBLE SYMPTOM:• Cruise control cannot be set. (Cancelled immediately.)• Cruise control cannot be released.Refer to DTC 11 for diagnostic procedure. D ...
To hook the top tether
CAUTION
Except for the center seating
position, remove the head restraint
when mounting a child
restraint system. Otherwise, it
might be possible that the top
tether cannot be fastened tightly.
For the center seating position,
raise the center head restraint to
the extended posit ...
