Subaru Crosstrek Service Manual: Removal
WIPER AND WASHER SYSTEMS > Front Washer Nozzle and Hose
REMOVAL
1. NOZZLE - WINDSHIELD WASHER & HOSE
1. Remove the arm assembly - windshield wiper. Front Wiper Arm > REMOVAL">
2. Remove the cowl panel - side and the cowl panel assembly. Cowl Panel > REMOVAL">
CAUTION:
Before removing the cowl panel, use an air blower and nylon brush to sweep gravel from the lower area of the front side of the glass.
3. Remove the nozzle - windshield washer.
(1) Push the claw using a flat tip screwdriver, etc.
(2) When the nozzle - windshield washer lifts up, pull out the nozzle - windshield washer using a clip remover, etc.
(3) Disconnect the hose - windshield washer, and remove the nozzle - windshield washer.
4. Disconnect the hose - windshield washer as necessary.
• Models without EyeSight
• Models with EyeSight
2. NOZZLE - WIPER ARM WASHER & HOSE (MODEL WITH EyeSight)
CAUTION:
Do not remove the nozzle - wiper arm washer from the arm assembly - windshield wiper assistor.
If nozzle replacement is required, replace the arm assembly - windshield wiper assistor as a unit.
1. Remove the arm assembly - windshield wiper. Front Wiper Arm > REMOVAL">
2. Remove the cowl panel - side and the cowl panel assembly. Cowl Panel > REMOVAL">
CAUTION:
Before removing the cowl panel, use an air blower and nylon brush to sweep gravel from the lower area of the front side of the glass.
3. Release the claws, and remove the cover - joint from cowl panel assembly.
4. Remove the hose - wiper arm washer.
Adjustment
WIPER AND WASHER SYSTEMS > Front Washer Nozzle and HoseADJUSTMENT1. NOZZLE - WINDSHIELD WASHER1. Turn the wiper switch to OFF position.2. While the vehicle is at a standstill, insert a precision sc ...
Inspection
WIPER AND WASHER SYSTEMS > Front Washer Nozzle and HoseINSPECTION• Make sure the nozzle - windshield washer and the hose - windshield washer are not clogged.• Make sure the hose - winds ...
Other materials:
Tips
The system can be armed even if the
engine hood, windows and/or moonroof
are open. Always make sure that they are
fully closed before arming the system.
The 30-second standby time can be
eliminated if you prefer. Have it performed
by your SUBARU dealer.
The system is in the standby ...
Inspection
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Subaru Select MonitorINSPECTION1. COMMUNICATION FOR INITIALIZING IMPOSSIBLECommunication error with auto headlight beam leveler CMDetecting condition:• Defective harness connector• Power supply circuit malfunction• Defective aut ...
Reverse Automatic Braking (RAB) system ON/OFF setting
In the Subaru Ascent, when the select lever is moved into the "R" (Reverse) position,
you gain access to customizable settings for the Reverse Automatic Braking (RAB)
system directly through the center information display. This allows the driver to
conveniently enable or disable key ...
