Subaru Crosstrek Owners Manual: Tips
- The system can be armed even if the engine hood, windows and/or moonroof are open. Always make sure that they are fully closed before arming the system.
- The 30-second standby time can be eliminated if you prefer. Have it performed by your SUBARU dealer.
- The system is in the standby mode for a 30-second period after locking the doors with the remote transmitter. The security indicator light will flash at short intervals during this period.
- If any of the following actions are done during the standby period, the system will not switch to the surveillance state.
Doors (including the rear gate) are unlocked using the access key/remote transmitter.
Doors (including the rear gate) are unlocked using the keyless access function (models with "keyless access with push-button start system").
Any door (including the rear gate) is opened.
The ignition switch is turned to the "ON" position (models without "keyless access with push-button start system").
Push-button ignition switch is turned to the "ACC" position (models with "keyless access with push-button start system").
To arm the system using access
key/remote transmitter
1. Close all windows and the moonroof (if
equipped).
2. Remove the key from the ignition
switch (models without "keyless access
with push-button start system")/turn the
push-button ignition swi ...
Other materials:
Dtc u0402 invalid data received from tcm
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0402 INVALID DATA RECEIVED FROM TCMThis is detected when CAN data from TCM is abnormal.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE"> ...
Fastening the seatbelt
WARNING
Never use a belt that is twisted or
reversed. In an accident, this can
increase the risk or severity of
injury.
Keep the lap belt as low as
possible on your hips. In a collision,
this spreads the force of the
lap belt over stronger hip bones
instead of across the weaker
...
Service diagnostics mode Operation
ENTERTAINMENT > Service Diagnostics ModeOPERATIONNOTE:Installed only to model with 7 inch display.1. PROCEDURE TO SWITCH TO SERVICE DIAGNOSTICS MODE1. Turn the ignition switch to ACC.2. After turning the ignition switch to ACC and wait for 20 seconds or more, press the button (b) five times with ...
