Subaru Crosstrek Owners Manual: Locking and unlocking from the inside
- Unlock
- Lock
To lock the door from the inside, rotate the lock lever forward. To unlock the door from the inside, rotate the lock lever rearward.
The red mark on the lock lever appears when the door is unlocked.
Pull the inside door handle to open an unlocked door.
Always make sure that all doors and the rear gate are closed before starting to drive.
WARNING
Keep all doors locked when you drive, especially when small children are in your vehicle.
Along with the proper use of seatbelts and child restraints, locking the doors reduces the chance of being thrown out of the vehicle in an accident.
It also helps prevent passengers from falling out if a door is accidentally opened, and intruders from unexpectedly opening doors and entering your vehicle.
Locking and unlocking from the outside
NOTE
If you unlock the driver's door with a
key (including a mechanical key) and
open the door while the alarm system
is armed, the alarm system is triggered
and the vehicle's horn sounds. In thi ...
Battery drainage prevention function
If a door or the rear gate is not completely
closed, the interior lights will remain
illuminated as a result. However, several
lights are automatically turned off by the
battery drainage preventio ...
Other materials:
Wiring diagram
LIGHTING SYSTEM > Stop Light SystemWIRING DIAGRAMRefer to “Stop Light System” in the wiring diagram.• Model without EyeSight: Stop Light System > WIRING DIAGRAM">• Model with EyeSight: Stop Light System > WIRING DIAGRAM"> ...
Removal
LUBRICATION(H4DO) > Oil Pressure SwitchREMOVALCAUTION:If the engine oil is spilt over exhaust pipe or the under cover, wipe it off with cloth to avoid emitting smoke or causing a fire.1. Disconnect the ground cable from battery. NOTE">2. Remove the rubber cap.3. Disconnect the terminal f ...
Installation
BRAKE > Master CylinderINSTALLATION1. Replace the seal sub assembly for the master cylinder assembly with a new part.CAUTION:Be careful not to install the seal sub assembly in the wrong location.(a)Primary piston(b)Seal sub ASSY(c)Install the seal sub assembly to this surface.2. Install each part ...
