Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Battery drainage prevention function

Subaru Crosstrek Owners Manual / Keys and doors / Door locks / Battery drainage prevention function

If a door or the rear gate is not completely closed, the interior lights will remain illuminated as a result. However, several lights are automatically turned off by the battery drainage prevention function to prevent the battery from discharging. The following interior lights are affected by this function.

Battery drainage prevention function

*1: The battery drainage prevention function affects only the map lights on models with the moonroof, and only when the map light switches are in the OFF position. The map lights on models without the moonroof do not turn off automatically, so push the light switches manually to turn them off.

The operational/non-operational setting of this function can be changed by a SUBARU dealer. Contact your SUBARU dealer to change the setting.

NOTE

Locking and unlocking from the inside
Unlock Lock To lock the door from the inside, rotate the lock lever forward. To unlock the door from the inside, rotate the lock lever rearward. The red mark on the lock lever appears ...

Power door locking switches
Lock Unlock All doors and the rear gate can be locked and unlocked by the power door locking switches located at the driver's side and the front passenger's side doors. To lock the d ...

Other materials:

Preparation tool
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Select Monitor ...

Removal
ENTERTAINMENT > Rearview Camera SystemREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear gate. Rear Gate Trim > REMOVAL">3. Remove the arm assembly - rear wiper. Rear Wiper Arm > REMOVAL">4. Remove the motor ...

Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Intake ManifoldINSTALLATION1. Install the engine wiring harness. Engine Wiring Harness > INSTALLATION">2. Install the intake manifold to the tumble generator valve assembly.NOTE:Use a new gasket.Tightening torque:8.3 N·m (0.8 kgf-m, 6.1 ft- ...

© 2016-2025 Copyright www.sucross.com