Subaru Crosstrek Owners Manual: Initialization of power window
If the vehicle's battery is disconnected due to situations such as battery or fuse replacement, the following functions are deactivated.
- One-touch auto up/down function
- Anti-entrapment function
Initialize the power window using the following procedure to reactivate these functions.
1. Close the driver's door.
2. Turn the ignition switch to the "ON" position.
3. Open the driver's side window halfway by pushing down the power window switch.
4. Pull up the power window switch and close the window completely. Continue pulling up the switch for approximately 1 second after the window is closed completely.
5. Open the driver's side window completely by fully pushing down the power windows switch.
Power window operation by passengers
Passenger's side power window switches
Each passenger window can be controlled
by the power window switch located on
the door.
Operating the windows
To open:
Press the switch down and ho ...
Rear gate
...
Other materials:
Dtc u0122 lost communication with vehicle dynamics control module
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0122 LOST COMMUNICATION WITH VEHICLE DYNAMICS CONTROL MODULENOTE:Refer to “LAN SYSTEM (DIAGNOSTICS)” for diagnostic procedures. Basic Diagnostic Procedure">1. OUTLIN ...
Inspection
COMMUNICATION SYSTEM > HornINSPECTION1. CHECK HORN ASSEMBLY1. Remove the horn assembly (Hi & Lo). Horn > REMOVAL">2. Check the horn sounds when applying the battery voltage to the horn assembly.Terminal No.Inspection conditionsSpecificationHorn terminal (+) — Horn case (−) ...
Steering warning light does not go off
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > STEERING Warning LightSTEERING WARNING LIGHT DOES NOT GO OFFDetecting condition:• Defective combination meter• Open circuit of harnessTrouble symptom:When starting the engine, the STEERING warning light continues to illuminate.STE ...
