Subaru Crosstrek Owners Manual: Key replacement
Your key number plate will be required if you ever need a replacement key made.
Any new key must be registered for use with your vehicle's immobilizer system before it can be used. The maximum number of keys that can be registered for use with one vehicle is as follows.
- Four (models without "keyless access with push-button start system")
- Seven (models with "keyless access with push-button start system")
One key that has already been registered is required in order to register a new key.
If you lose a key, the lost key's ID code still remains in the memory of the vehicle's immobilizer system. For security reasons, the lost key's ID code should be erased from the memory. To erase the lost key's ID code, all keys that will be used are required.
For details about new key registration and erasing the lost key's ID code, contact your SUBARU dealer.
Immobilizer
The immobilizer system is designed to
prevent an unauthorized person from
starting the engine. Only keys registered
with your vehicle's immobilizer system can
be used to operate your vehicle. This ...
Certification for immobilizer system
For models with "keyless access
with push-button start system":
Refer to "Certification for keyless access
with push-button start system" 2-19.
For models without "keyless access
wi ...
Other materials:
Specification
VEHICLE DYNAMICS CONTROL (VDC) > VDC Sequence ControlSPECIFICATION1. CONDITIONS FOR COMPLETION OF VDC SEQUENCE CONTROLWhen the following conditions develop, the VDC sequence control stops and VDC operation is returned to the normal control mode.• When the speed of at least one wheel reaches ...
List of diagnostic trouble code (dtc) List
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > List of Diagnostic Trouble Code (DTC)LISTDTCItemReferenceB2300REAR RADAR CIRCUIT LOW Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2300 REAR RADAR CIRCUIT LOW">B2301REAR RADAR CIRCUIT HIGH Diagnostic Procedu ...
Assembly
CLUTCH SYSTEM > Operating CylinderASSEMBLYNOTE:During assembly, apply hydraulic oil to all parts.Recommended brake fluid:New FMVSS No. 116 DOT3 or DOT41. Install the piston spring.2. Insert piston into the operating cylinder.3. Install push rod to the boot.4. Install the boot and push rod. ...
