Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Engine low oil level warning light

This light illuminates when the engine oil level decreases to the lower limit.

If the engine low oil level warning light illuminates while driving, park the vehicle in a safe and level location, and then check the engine oil level. When the engine oil level is not within the normal range, refill with engine oil. Refer to "Engine oil"

If the warning light does not turn off after refilling the engine oil, or the warning light illuminates even though the engine oil level is within the normal range, have the vehicle checked by a SUBARU dealer.

NOTE

After replacing or adding the engine oil, if the engine oil level is within the normal range when restarting the engine on a level surface, the warning light will turn off.

The warning light may illuminate temporarily in the following conditions because a low oil level may be detected as a result of significant oil movement in the engine.

Windshield washer fluid warning light

This light illuminates when the fluid level in the windshield washer fluid tank decreases to the lower limit (approximately 1.1 US qt, 1.0 liter, 0.9 Imp qt).

Oil pressure warning light
If this light illuminates when the engine is running, it may indicate that the engine oil pressure is low and the lubricating system is not working properly. If the light illuminates while d ...

At oil temp warning light (CVT models)
If this light illuminates when the engine is running, it may indicate that the transmission fluid temperature is too hot. If the light illuminates while driving, immediately stop the vehicl ...

Other materials:

BSD/RCTA approach indicator light
BSD/RCTA approach indicator light It is mounted on each side of the outside mirrors. The indicator light will illuminate when a vehicle approaching from behind is detected. The indicator light will flash to warn the driver of dangers under the following conditions. While the indic ...

Radiator cap Inspection
COOLING(H4DO) > Radiator CapINSPECTION1. Check that the radiator cap does not have deformation, cracks or damage.2. Attach the radiator cap tester to radiator cap.3. Increase pressure until the radiator cap tester gauge needle stops. Radiator cap is functioning properly if it holds the service li ...

Dtc p0606 control module processor
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0606 CONTROL MODULE PROCESSORDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Improper idling• Poor driving performanceCAUTION:After servicing or replacing faulty parts, p ...

© 2016-2026 Copyright www.sucross.com