Subaru Crosstrek Service Manual: Dtc b11f7 side impact deployment
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble Code
DTC B11F7 SIDE IMPACT DEPLOYMENT
DIAGNOSIS START CONDITION:
Ignition voltage is 10 V to 16 V.
DTC DETECTING CONDITION:
This DTC is displayed when the side airbag module and curtain airbag module are deployed.
Once this DTC is displayed, the memory cannot be cleared. Replace the following parts.
• Airbag control module Airbag Control Module">
• Side airbag module (operating side) Side Airbag Module">
• Side airbag sensor (operating side) Side Airbag Sensor">
• Curtain airbag module (operating side) Curtain Airbag Module">
• Curtain airbag sensor (operating side) Curtain Airbag Sensor">
• Satellite safing sensor Satellite Safing Sensor">
• Front door impact sensor (operating side) Front Door Impact Sensor">
• Front outer seat belt with pretensioner on the collision side (when activated) Front Seat Belt">
Dtc b11f5 front impact deployment
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B11F5 FRONT IMPACT DEPLOYMENTNOTE:For details on DTC B11F5, refer to DTC B11F2. Diagnostic Chart with Trouble Code > DTC B11F ...
Dtc b11f8 side impact deployment
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B11F8 SIDE IMPACT DEPLOYMENTNOTE:For details on DTC B11F8. refer to DTC B11F7. Diagnostic Chart with Trouble Code > DTC B11F7 ...
Other materials:
Assembly
STARTING/CHARGING SYSTEMS(H4DO) > StarterASSEMBLY1. Apply grease to the shaft sliding surfaces of the internal gear assembly.Grease:Multemp #6129 or equivalent2. Assemble the shaft to the internal gear assembly.3. Assemble the overrunning clutch as follows:(1) Apply grease to the spline portion o ...
Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Driven GearREMOVAL1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">2. Remove the back-up light switch and the neutral position switch. Switches and Harness > REMOVAL">3 ...
Removal
LIGHTING SYSTEM > Front Fog Light AssemblyREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle.3. Remove the screw and clips, and turn over the front side of the mud guard - front.4. From the bottom of the bumper face - front, remove the fog light assembly - f ...
