Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: ABS warning light

CAUTION

If any of the following conditions occur, we recommend that you have the ABS repaired at the first available opportunity by your SUBARU dealer.

When the warning light is on (and the brake system warning light is off), the ABS function shuts down. However, the conventional brake system continues to operate normally.

The ABS warning light illuminates together with the brake system warning light if the EBD system malfunctions. For further details of the EBD system malfunction warning, refer to "Electronic Brake Force Distribution (EBD) system warning"

NOTE

If the warning light behavior is as described in the following conditions, the ABS may be considered normal.

When driving with an insufficient battery voltage such as when the engine is jump started, the ABS warning light may illuminate.

This is due to the low battery voltage and does not indicate a malfunction.

When the battery becomes fully charged, the light will turn off.

Low tire pressure warning light (U.S.-spec. models)
When the ignition switch is turned to the "ON" position, the low tire pressure warning light will illuminate for approximately 2 seconds to check that the tire pressure monitoring system (TPMS ...

Brake system warning light (red)
The light illuminates with the parking brake applied while the ignition switch is in the "ON" position. It turns off when the parking brake is fully released. WARNING Driving with the brak ...

Other materials:

Adjustment
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Drive Pinion Shaft AssemblyADJUSTMENT1. THRUST BEARING PRELOAD1. Select a suitable adjusting washer No. 1 so that dimension (H) will be zero in a visual check. Position the washer (18.3 ? 30 ? t) and lock washer (18 ? 30 ? 2) and attach the lock nut.2. ...

Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Reduction Drive GearREMOVAL1. Remove the transmission assembly from the vehicle. Automatic Transmission Assembly > REMOVAL">2. Remove the air breather hose. Air Breather Hose > REMOVAL">3. Remove the control valve body. Control ...

Inspection
CONTROL SYSTEMS > AT Shift Lock Solenoid and “P” Range SwitchINSPECTIONSTEPCHECKYESNO1.CHECK SOLENOID UNIT.Measure the resistance of solenoid unit connector terminals.TerminalsNo. 4 — No. 3:Is the resistance 27.6 — 30.5 ?? AT Shift Lock Solenoid and “P” Range Switch &g ...

© 2016-2025 Copyright www.sucross.com