Subaru Crosstrek Service Manual: Caution

1. SUPPLEMENTAL RESTRAINT SYSTEM “AIRBAG”

Airbag system wiring harness is routed near the ABS wheel speed sensor and VDCCM&H/U.

CAUTION:

• Do not use electrical test equipment on wiring harness and connector circuits of the airbag system.

• Be careful not to damage the airbag system wiring harness when servicing the ABS wheel speed sensor and VDCCM&H/U.

General description

Preparation tool

Other materials:

Inspection mode Operation
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Inspection ModeOPERATIONIt is possible to diagnose the DTC by performing the indicated inspection mode. After correcting the DTC, perform a necessary inspection mode and make sure that the function is resumed correctly and the DTC is r ...

System temporary stop indicator
System temporary stop indicator This indicator appears when the system is used under the following conditions. Extremely high or low temperatures When abnormal voltage exists for the vehicle battery When the radar sensor is significantly misaligned Once the above conditions are ...

Removal
LIGHTING SYSTEM > Ignition Switch IlluminationREMOVALNOTE:The ignition switch illumination is integrated into the immobilizer antenna assembly.1. Disconnect the ground cable from battery. NOTE">2. Remove the cover assembly - column.(1) Remove the screws by turning the steering wheel to r ...