Subaru Crosstrek Service Manual: Stop light brake switch Note
EyeSight > Stop Light & Brake Switch
NOTE
For the operation procedures for stop light and brake switch, refer to “BRAKE” section. Stop Light Switch">
Roll connector Note
EyeSight > Roll ConnectorNOTEFor the operation procedures for roll connector (steering angle sensor), refer to “AIRBAG SYSTEM” section. Roll Connector"> ...
Transmission control module (tcm) Note
EyeSight > Transmission Control Module (TCM)NOTEFor the operation procedures for transmission control module (TCM), refer to “CONTINUOUSLY VARIABLE TRANSMISSION” section. Transmission ...
Other materials:
Removal
LIGHTING SYSTEM > Rear Combination Light AssemblyREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful not to damage the clips.(1) Release the bolts and clips, then pull out the light assembly - rear ...
Arming the system
The Subaru Ascent alarm system is automatically armed when a specific sequence
of actions is completed, ensuring reliable protection of the vehicle and its contents
against unauthorized access.
1. Fully close all windows and the moonroof (if equipped), then turn the ignition
switch of your Su ...
Steering warning light does not come on
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > STEERING Warning LightSTEERING WARNING LIGHT DOES NOT COME ON1. POWER STEERING ASSIST ENABLEDDetecting condition:• Defective combination meter• Defective harnessTrouble symptom:When the ignition switch is turned to ON (engine OFF) ...
