Subaru Crosstrek Service Manual: Installation
SECURITY AND LOCKS > Rear Door Latch and Door Lock Actuator Assembly
INSTALLATION
1. Before installation, check the following items.
• Lever is free from deformation.
• Grease is applied sufficiently to lever joints.
If grease is insufficient, add it as necessary before assembling.
• If the lever is faulty, replace the rear outer handle.
• If the lever is deformed, replace the latch & actuator assembly - rear.
2. Install each part in the reverse order of removal.
CAUTION:
Do not reuse the screws of the latch and actuator assembly - rear. Always replace with a new part.
Tightening torque:
Refer to “COMPONENT” of “General Description”. General Description > COMPONENT">
NOTE:
Make sure the child safety lock works correctly after installation.
Removal
SECURITY AND LOCKS > Rear Door Latch and Door Lock Actuator AssemblyREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear door. Door Trim > REMOVAL& ...
Other materials:
Caution
AIRBAG SYSTEM > General DescriptionCAUTION1. BEFORE STARTING ALL WORKS• Before performing vehicle maintenance, turn the ignition switch to OFF and disconnect the negative terminal from battery. NOTE">• The airbag system (including pretensioner) is fitted with a backup power s ...
Dtc b1826 open in side airbag lh
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1826 OPEN IN SIDE AIRBAG LHDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Side airbag harness (LH) circuit is open.• Side airbag module (LH) is faulty.• Airbag control modu ...
Removal
DRIVE SHAFT SYSTEM > Rear Drive ShaftREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and then remove the rear wheels.3. Remove the axle nut.CAUTION:Do not loosen the axle nut while the rear axle is loaded. Doing so may damage the hub unit bearing.(1) Lif ...
