Subaru Crosstrek Service Manual: Caution
SECURITY AND LOCKS > General Description
CAUTION
• Before disassembling or reassembling parts, always disconnect the battery ground cable from battery. When replacing the audio, control module and other parts provided with memory functions, record the memory contents before disconnecting the battery ground cable. Otherwise, the memory is cleared.
• Reassemble the parts in the reverse order of disassembly procedure unless otherwise indicated.
• Connect the connectors securely during reassembly.
• After reassembly, make sure that the each component operates normally.
• If any immobilizer related part has been replaced, make sure to register the immobilizer.
• Be careful of the following items. Failing to do so may cause the airbag system malfunction.
– Yellow connectors and harnesses with yellow tapes around them are the connectors and harnesses for the airbag system. When using a tester on these circuits, follow the cautions of “AIRBAG SYSTEM”. General Description > CAUTION">
– Be careful not to damage the airbag system wiring harness when servicing the electrical parts around the steering column.
• Be careful not to damage the airbag system wiring harness when servicing the ignition key cylinder.
• If the steering wheel and steering angle sensor (steering roll connector) are removed, perform the VDC midpoint setting mode. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT">
Preparation tool
SECURITY AND LOCKS > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for ...
Other materials:
Power door locking switches
Lock
Unlock
All doors and the rear gate can be locked
and unlocked by the power door locking
switches located at the driver's side and
the front passenger's side doors.
To lock the doors, push the front side of
the switch.
To unlock the doors, push the rear side of
the switch. ...
Vdc off indicator light does not go off
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Warning Light Illumination PatternVDC OFF INDICATOR LIGHT DOES NOT GO OFFDetecting condition:• Defective combination meter• Defective CAN communication• VDC OFF switch is shorted.Trouble symptom:VDC OFF indicator light does not go o ...
Rear door window sunshades
Hook
In the Subaru Ascent, the rear door window sunshades are seamlessly integrated
into the rear door trim, offering both comfort and protection from direct sunlight
for rear passengers.
To activate the sunshade in your Subaru Ascent, gently pull it upward and securely
attach it to ...
