Subaru Crosstrek Service Manual: Installation
SECURITY AND LOCKS > Body Integrated Unit
INSTALLATION
CAUTION:
• When the control module related to immobilizer has been replaced, be sure to perform the registration of immobilizer system. For detailed operation procedure, refer to “Type B” described in “REGISTRATION MANUAL FOR IMMOBILIZER”.
• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">
• Do not allow harness and connectors to interfere or get tangled up with other parts.
Install each part in the reverse order of removal.
Tightening torque:
Relay & fuse box: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
NOTE:
Make sure that there are no differences from the contents of the current settings after installation. Read Current Data > LIST">
Removal
SECURITY AND LOCKS > Body Integrated UnitREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM&rdq ...
Other materials:
Airbag warning light illumination pattern Inspection
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Airbag Warning Light Illumination PatternINSPECTIONTurn the ignition switch to ON, and confirm that the airbag warning light remains on for approx. 6 seconds then turns off afterwards.(1)Airbag warning light(2)Approx. 6 seconds(3)Ignition switch ON ...
EyeSight (models with EyeSight
system)
NOTE
For models with the EyeSight system,
refer to the Owner's Manual supplement
for the EyeSight system.
BSD/RCTA (if equipped)
After entering the "BSD/RCTA" menu,
select the "Warning Volume" menu. You
can set the volume of the warning buzzer
for RCTA (Rear Cross Traffic Alert). You
can se ...
Installation
COOLING(H4DO) > Water PumpINSTALLATION1. WATER PUMP PULLEY1. Using the ST, install the water pump pulley.ST1 18355AA000PULLEY WRENCHST2 18334AA030PULLEY WRENCH PIN SETTightening torque:14 N·m (1.4 kgf-m, 10.3 ft-lb)2. Install the under cover. Front Under Cover > INSTALLATION" ...
