Subaru Crosstrek Service Manual: Inspection
SECURITY AND LOCKS > Rear Gate Opener Button
INSPECTION
Preparation tool:
Circuit tester
1. Check the resistance between switch terminals.
Terminal No. | Inspection conditions | Standard | Connection diagram |
1 — 2 | OPEN | Less than 5 ? |
• Model without keyless access with push button start
• Model with keyless access with push button start
CLOSE
1 M? or more
2. If the inspection result is not within the standard, replace the button - opener rear gate.
Removal
SECURITY AND LOCKS > Rear Gate Opener ButtonREMOVALNOTE:• The button - opener rear gate is integrated with the rear lock button. (Model with keyless access with push button start)• Open ...
Other materials:
Note
LIGHTING SYSTEM > Clearance Light and Illumination Light SystemNOTEFor operation procedures of each component of the clearance light & illumination light system, refer to the respective sections.• Combination switch (light): Combination Switch (Light)">• Parking light bul ...
Dtc p0134 a/f / o2 sensor circuit no activity detected bank 1 sensor 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0134 A/F / O2 SENSOR CIRCUIT NO ACTIVITY DETECTED BANK 1 SENSOR 1DTC detecting condition:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Mem ...
Dtc u0073 control module communication bus off
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0073 CONTROL MODULE COMMUNICATION BUS OFFDetected when CAN line abnormality is detected.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE&q ...
