Subaru Crosstrek Service Manual: Dtc c0045 tcm malfunction

DTC detecting condition:

Defective TCM

Trouble symptom:

• ABS does not operate.

• VDC does not operate.

• EyeSight does not operate.

1.CHECK CVT SYSTEM.

1) Start the engine.

2) Read the DTC of the CVT system. Read Diagnostic Trouble Code (DTC)">

Is DTC of CVT system displayed?

Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)">

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C0045 TCM MALFUNCTION">Go to Step 2.

2.CHECK VDCCM&H/U.

1) Perform the Clear Memory Mode. Clear Memory Mode">

2) Perform the Inspection Mode. Inspection Mode">

3) Read the DTC. Read Diagnostic Trouble Code (DTC)">

Is the same DTC displayed?

Replace the VDCCM&H/U. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)">

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C0045 TCM MALFUNCTION">Go to Step 3.

3.CHECK DETECTION OF OTHER DTCS FOR VDC.

Read Diagnostic Trouble Code (DTC)">

Is any other DTC displayed?

Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)">

Currently, it is normal. There may have been a temporary poor contact in the harness and connector or a temporary noise interference.

Dtc c0045 incorrect vdc control module specifications

Dtc c0051 valve relay

Other materials:

Driver Monitoring System
The Driver Monitoring System, known in some markets as DriverFocus, is an advanced safety and personalization feature integrated into the Subaru Ascent. This intelligent system continuously observes the driver’s behavior to detect signs of distraction or reduced attention, while also identif ...

Removal
DIFFERENTIALS > Rear Differential (T-type)REMOVAL1. Shift the select lever or gear shift lever to neutral.2. Release the parking brake.3. Disconnect the ground cable from battery.4. Lift up the vehicle.5. Remove the rear wheels.6. Drain differential gear oil. Differential Gear Oil > REPLACEME ...

Removal
BRAKE > Brake BoosterREMOVALCAUTION:• Do not allow brake fluid to come in contact with the painted surface of the vehicle body. If it does, wash off with water and wipe away completely.• Before handling the airbag system components, always refer to “CAUTION” of “Gene ...