Subaru Crosstrek Service Manual: Steering lock cm
Installation
SECURITY AND LOCKS > Starter Relay (Push Button Start)INSTALLATIONCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in &ldquo ...
Inspection
SECURITY AND LOCKS > Steering Lock CMINSPECTION1. Check if the steering lock is released when you start the engine using the push button ignition switch.2. If the system does not operate normally a ...
Other materials:
Regarding access key
CAUTION
If the access key is dropped, the
integrated mechanical key inside
may become loose. Be careful not
to lose the mechanical key.
NOTE
The access key is always communicating
with the vehicle and is continuously
using the battery. Although
the life of the battery varies depending
on t ...
Canceling the function for meter/gauge needle movement upon turning on the
ignition switch
It is possible to activate or deactivate the
movement of the meter needles and
gauge needles that takes place when the
ignition switch is turned to the "ON"
position.
Type A combination meter
To change the setting, perform the following
procedure.
1. Turn the ignition switch to the "LOCK"/ ...
Control module i/o signal Electrical specification
BODY CONTROL SYSTEM (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATIONDescriptionTerminal No.Signal (V or ?)NoteIgnition switch ON(Engine OFF)Ignition power supply (rear wiper)A5 ←> Chassis groundLess than 1.5 V > 10 — 13 VIgnition switch OFF > ONBattery power suppl ...
