Subaru Crosstrek Service Manual: Installation
SECURITY AND LOCKS > Front Outer Handle
INSTALLATION
1. Before installation, check the following items.
• Rod is free from deformation.
• Grease is applied sufficiently to rod joints.
If grease is insufficient, add it as necessary before assembling the rod.
• If the lever is faulty, replace the front outer handle.
• If the rod is deformed, replace the latch & actuator assembly - front.
2. Install each part in the reverse order of removal.
CAUTION:
When installing the cover - handle front outer on driver’s side, make sure that the key cylinder shaft is correctly inserted into the latch & actuator assembly - front.
Tightening torque:
Refer to “COMPONENT” of “General Description”. General Description > COMPONENT">
Removal
SECURITY AND LOCKS > Front Outer HandleREMOVAL1. Raise the glass assembly - front door to the top position.2. Disconnect the ground cable from battery and wait for at least 60 seconds before starti ...
Other materials:
Dtc b2a09 i-call button circuit
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A09 I-CALL BUTTON CIRCUITDiagnosis start condition:When ignition switch is ON.DTC detecting condition:The following conditions occur for at least 50 ms.• i-button impedance is more than 10 k?.&bul ...
Assembly
COOLING(H4DO) > Radiator Sub Fan and Fan MotorASSEMBLYAssemble in the reverse order of disassembly.Tightening torque:4.41 N·m (0.45 kgf-m, 3.25 ft-lb)Tightening torque:3.4 N·m (0.3 kgf-m, 2.5 ft-lb) ...
Disposal of pretensioner Procedure
SEAT BELT SYSTEM > Disposal of PretensionerPROCEDUREWARNING:Make sure to follow the instructions below. Otherwise, personal injuries may occur.• Before discarding a pretensioner, always perform an activation process to prevent any false activation.• Wear protective gloves, safety gogg ...
