SECURITY AND LOCKS > Remote Openers
INSTALLATION
1. Before installation, check the following items.
• Cable is free from deformation such as fray.
2. Install each part in the reverse order of removal.
Tightening torque:
Front hood lock: General Description > COMPONENT">
Remote opener: General Description > COMPONENT">
RemovalInspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.NOTE:If the fuse is blown again, check the system wiring harness.2. CHECK RELAY1. Check the resistance between relay terminals.&bul ...
Determining compatibility of tire and vehicle load capacities
The sum of four tires' maximum
load ratings must exceed the maximum
loaded vehicle weight
("GVWR"). In addition, sum of the
maximum load ratings of two front
tires and of two rear tires must
exceed each axle's maximum
loaded capacity ("GAWR"). Original
equipment tires are designed to
fulfil ...
Installation
STARTING/CHARGING SYSTEMS(H4DO) > BatteryINSTALLATIONCAUTION:After the battery is installed, initial diagnosis of the electronic throttle control is performed. Wait for 10 seconds or more after turning the ignition switch to ON, and then start the engine.1. Install the battery.2. Set the battery ...