Subaru Crosstrek Service Manual: Inspection
SECURITY AND LOCKS > Keyless Transmitter
INSPECTION
1. KEYLESS TRANSMITTER BATTERY
1. Check the keyless transmitter battery voltage.
PREPARATION TOOL:
Circuit tester
NOTE:
Complete the measurement within 5 seconds because the battery discharges during measurement.
Battery terminal | Inspection Conditions | Standard |
(+) — (−) | Connect resistor (A) 47 ? | 2.5 — 3.0 V |
2. Replace the battery if the inspection result is not within the standard. (Use CR1620 or equivalent.)
Replacement
SECURITY AND LOCKS > Keyless TransmitterREPLACEMENT1. REGISTRATION OF KEYLESS TRANSMITTER WITH SUBARU SELECT MONITORNOTE:• A maximum of four keyless transmitters can be registered for each in ...
Other materials:
Bypass screen setting
1. Perform the preparation steps according
to "Preparation for screen settings"
2. Operate the "
" or "
" switch to
select the "Bypass Screen" item. Then
push the
button.
3. Select the item to set by operating the
"
" or "
" switches. Then push the
button ...
Dtc c0021 front right abs sensor circuit open or short
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0021 FRONT RIGHT ABS SENSOR CIRCUIT OPEN OR SHORTNOTE:For the diagnostic procedure, refer to “DTC C0027 REAR LEFT ABS SENSOR CIRCUIT OPEN OR SHORT”. Diagnostic Procedure with Di ...
Rear towing hook
1. Take the towing hook and screwdriver
out of the tool bucket. Take the jack
handle out of the cargo area.
2. Pry off the cover on the rear bumper
using a screwdriver, and you will find a
threaded hole for attaching the towing
hook.
3. Screw the towing hook into the thread
hole unti ...
