Subaru Crosstrek Service Manual: Replacement

1. REGISTRATION OF KEYLESS TRANSMITTER WITH SUBARU SELECT MONITOR

NOTE:

• A maximum of four keyless transmitters can be registered for each individual vehicle.

• When replacing or adding the keyless transmitter, new registration of transmitter is necessary.

1. Register the transmitter.

(1) Connect the Subaru Select Monitor to data link connector.

NOTE:

For detailed operation procedures, refer to “Application help”.

(2) Turn the ignition switch to ON.

(3) On «Start» display, select «Diagnosis».

(4) On «Vehicle selection» display, input the target vehicle information and select «Confirmed».

(5) On «Main Menu» display, select «Each System».

(6) On «Select System» display, select «Body Control» and then select «Enter».

(7) On «Select Function» display, select «Work Support».

(8) From the work support item list, select «Keyless ID registration».

(9) According to the directions on the screen, press the button of the transmitter to be registered in order of Lock > Unlock. When registration completed, external buzzer sound once. Repeat the registration as many times as desired.

(10) Press the [Exit] button to finish the operations.

NOTE:

When attempting to register a key that has already been registered, the external buzzer sounds twice.

Inspection

Installation

Other materials:

Installation
ENTERTAINMENT > Data Communication ModuleINSTALLATION1. DATA COMMUNICATION MODULECAUTION:• After installing the center grille assembly, check that the air vent grille of the center grille assembly is inserted correctly into the air vent duct.• Before handling the airbag system compone ...

General diagnostic table Inspection
DRIVE SHAFT SYSTEM > General Diagnostic TableINSPECTIONNOTE:Vibration while cruising may be caused by an unbalanced tire, improper tire inflation pressure, improper wheel alignment, etc.SymptomsPossible causeCorrective actionNoise or vibration from propeller shaft• Center bearing• Run ...

Maintenance
Carry some emergency equipment, such as a window scraper, a bag of sand, flares, a small shovel and jumper cables. Check the battery and cables. Cold temperatures reduce battery capacity. The battery must be in good condition to provide enough power for cold winter starts. It normally ...