Subaru Crosstrek Service Manual: Operation

1. On «Start» display, select «Diagnosis».

2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».

3. On «Main Menu» display, select «Each System».

4. On «Select System» display, select «EyeSight» and select «Enter».

5. On «Select Function» display, select «DTC».

NOTE:

• For detailed operation procedures, refer to “Application help”.

• For details concerning DTC, refer to “List of Diagnostic Trouble Code (DTC)”. Diagnostic Code(s) Display > LIST">

• Up to ten codes can be stored. When more than ten codes are output, they will not be stored.

• The same code is stored only once, and even when the same code occurs several times, information will not be updated.

List

Diagnostic procedure with diagnostic trouble code (dtc)

Other materials:

Checking the oil level
1. Park the vehicle on a level surface and turn the ignition switch to the "LOCK"/ "OFF" position. If you check the oil level just after turning the ignition switch to the "LOCK"/"OFF" position, wait a few minutes for the oil to drain back into the oil pan before checking the level. Oi ...

List
EyeSight (DIAGNOSTICS) > ACC Cancel Code(s) DisplayLIST• List of ACC cancel code(s)ACC cancel codeItemContents of diagnosis02ACC Mode:Maintaining Standstill PositionDisplayed when the cruise control is cancelled after the own vehicle stops following the preceding vehicle.04ACC Mode:Stereo C ...

Component
STARTING/CHARGING SYSTEMS(H4DO) > General DescriptionCOMPONENT1. STARTER(1)Starter housing ASSY(9)Overrunning clutch(17)Sleeve bearing(2)Sleeve bearing(10)Internal gear ASSY(18)Starter cover ASSY(3)Shift lever(11)Shaft (4)Plate(12)Pinion gearTightening torque: N·m (kgf-m, ft-lb)(5)Seal rub ...