Subaru Crosstrek Owners Manual: Windshield wipers
Mist (for a single wipe)
Off
Intermitten
Low speed
High speed
To turn the wipers on, push the wiper control lever down.
To turn the wipers off, return the lever to
the " 
" position.
For a single wipe of the wipers, push the lever up. The wipers operate until you release the lever.
Windshield wiper and washer switches
The wiper operates only when the ignition
switch is in the "ON" or "ACC" position. ...
Wiper intermittent time control
When the wiper switch is in the "
"
position, turn the dial to adjust the operating
interval of the wiper. The operating
interval can be adjusted in several steps
from the shortest interval ...
Other materials:
System maintenance
NOTE
For models without "keyless access
with push-button start system":
In the event that the vehicle's battery is
replaced, discharged or disconnected,
it will be necessary to start the vehicle
a minimum of one time using the key
prior to activating the remote engine
start system. This is r ...
Removal
STARTING/CHARGING SYSTEMS(H4DO) > BatteryREMOVAL1. Disconnect the positive (+) terminal after disconnecting the negative (−) terminal of battery.2. Remove the battery cable holder from the battery rod.3. Remove the flange nut from battery rod and remove battery holder.4. Remove the battery. ...
System operation
Operating conditions
The BSD/RCTA system in the Subaru Ascent functions only when specific operating
requirements are satisfied. These conditions ensure accurate detection and reliable
system performance.
The ignition switch of the Subaru Ascent is in the "ON" position.
The BSD/ ...
