Subaru Crosstrek Service Manual: Installation
LUBRICATION(H4DO) > Engine Oil Filter
INSTALLATION
1. OIL FILTER
CAUTION:
Do not tighten excessively, or oil may leak.
1. Clean the oil filter installation surface.
2. Obtain a new oil filter and apply a thin coat of engine oil to the seal rubber.
3. Install the oil filter by turning it by hand, being careful not to damage the seal rubber of the oil filter.
• Tighten the oil filter (black) with an outer diameter of 68 mm (2.68 in) (approx. 1 rotation) after the seal rubber of the oil filter comes in contact with chain cover. When using a torque wrench, tighten to 14 N·m (1.4 kgf-m, 10.3 ft-lb).
• Tighten the oil filter (blue) with an outer diameter of 67.4 mm (2.65 in) (approx. 7/8 rotation) after the seal rubber of the oil filter comes in contact with chain cover. When using a torque wrench, tighten to 12 N·m (1.2 kgf-m, 8.9 ft-lb).
4. After installing, check the engine oil level and replenish it if necessary. Engine Oil > INSPECTION">
2. OIL PUMP UNION
Install in the reverse order of removal.
Tightening torque:
45 N·m (4.6 kgf-m, 33.2 ft-lb)
Removal
LUBRICATION(H4DO) > Engine Oil FilterREMOVALCAUTION:If the engine oil is spilt over exhaust pipe or the under cover, wipe it off with cloth to avoid emitting smoke or causing a fire.1. OIL FILTER1. ...
Other materials:
Making a call
There are several methods by which a call
can be made, as described below.
1. Press the HOME button on the audio
panel.
2. Touch the "PHONE" key.
3. Select the desired key to make a call
from the list.
Item
Function
Incoming
Calls
Display the history of inco ...
Dtc b2274 acc relay control circuit
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2274 ACC RELAY CONTROL CIRCUITDTC detecting condition:When malfunction is detected in ACC relay drive circuit in the keyless access CM or external circuit.Trouble symptom:Each ...
Removal
EXTERIOR/INTERIOR TRIM > Console BoxREMOVAL1. Disconnect the ground cable from battery. NOTE">NOTE:On CVT models, shift the select lever into “N” before disconnecting the battery ground cable.2. Remove the console box assembly.(1) Release the claws, and then remove the boot - ...
