Subaru Crosstrek Service Manual: Immobilizer control module Note
SECURITY AND LOCKS > Immobilizer Control Module
NOTE
The control of immobilizer system is carried out in body integrated unit. Refer to the section on the body integrated unit for the work procedures. Body Integrated Unit">
Id code box Note
SECURITY AND LOCKS > ID Code BoxNOTENOTE:• Equipped on C5 model with keyless access with push button start.• The ID code box is located at the place of security control module.Refer to ...
Key lock cylinders Replacement
SECURITY AND LOCKS > Key Lock CylindersREPLACEMENT1. STEERING LOCK1. Disconnect the ground cable from battery. NOTE">2. Remove the cover assembly - column.(1) Remove the screws by turning ...
Other materials:
Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Primary Speed SensorREMOVALCAUTION:Be sure to prevent water or oil from contacting the connector terminal of primary speed sensor. If adhesion occurs, replace with a new part.1. Remove the transmission assembly. Automatic Transmission Assembly > REM ...
Key replacement
Your key number plate will be required if
you ever need a replacement key made.
Any new key must be registered for use
with your vehicle's immobilizer system
before it can be used. The maximum
number of keys that can be registered
for use with one vehicle is as follows.
Four (models with ...
Dtc b2304 rear radar on-off switch stuck
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2304 REAR RADAR ON-OFF SWITCH STUCKDTC detecting condition:• BSD/RCTA OFF switch is stuck to ON. (Switch malfunction)• Switch was left pressed for a prolonged time ...
