Subaru Crosstrek Service Manual: Electrical specification
SECURITY AND LOCKS > Keyless Access System
ELECTRICAL SPECIFICATION
Refer to “Control Module I/O Signal” of “KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS)” section. Control Module I/O Signal > ELECTRICAL SPECIFICATION">
Wiring diagram
SECURITY AND LOCKS > Keyless Access SystemWIRING DIAGRAMFor wiring diagrams related to the keyless access system, refer to the following items.• Keyless access system: Keyless Access System ...
Other materials:
Installation
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > EGR CoolerINSTALLATION1. Set the gasket to the stud bolt.NOTE:Use a new gasket.2. Temporarily tighten the bolts securing the EGR cooler to the EGR control valve and the cylinder head RH, and tighten in numerical order.NOTE:Use a new gasket. ...
Malfunction indicator light does not go off
ENGINE (DIAGNOSTICS)(H4DO) > Malfunction Indicator LightMALFUNCTION INDICATOR LIGHT DOES NOT GO OFFTROUBLE SYMPTOM:Although malfunction indicator light comes on when the engine runs, DTC is not shown on the Subaru Select Monitor or general scan tool display.STEPCHECKYESNO1.CHECK DTC.Is DTC of eng ...
Replacement
DIFFERENTIALS > Rear Differential Side Oil SealREPLACEMENT1. Remove the rear differential. Rear Differential (T-type) > REMOVAL"> Rear Differential (VA-type) > REMOVAL">2. Remove the rear differential side oil seal using a ST or screwdriver wrapped with vinyl tape to preve ...
