Subaru Crosstrek Service Manual: Inspection
SECURITY AND LOCKS > Receiver
INSPECTION
1. Check if the door lock operates when the touch sensor of the door outer handle and rear lock button is operated.
2. If the system does not operate normally as the result of inspection, refer to “General Diagnostic Table” of the “KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS)” section. General Diagnostic Table > INSPECTION">
Receiver
...
Removal
SECURITY AND LOCKS > ReceiverREMOVALNOTE:Except for model with keyless entry1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear apron LH. Rear Quarter Trim ...
Other materials:
Starter motor circuit
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostics for Engine Starting FailureSTARTER MOTOR CIRCUIT1. MODEL WITHOUT PUSH BUTTON STARTCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode">, and Inspection Mode Inspection Mode">.Wiring diagram:Engin ...
Tripped sensor identification
The security indicator light flashes when
the alarm system has been triggered.
Also, the number of flashes indicates the
location of unauthorized intrusion or the
severity of impact on the vehicle.
When the ignition switch is turned to the
"ON" position, the indicator light will light
for ...
Basic information before use
WARNING
When the vehicle is stopped with the
engine running, always apply the
parking brake for safety. Failure to
do so may result in loss of control of
your vehicle and cause an accident
or serious injury.
CAUTION
To prevent damaging the screen,
touch the screen keys with your
finge ...
