Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Electrical specification

SECURITY AND LOCKS > Push Button Start System

ELECTRICAL SPECIFICATION

Refer to “Control Module I/O Signal” of “KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS)” section. Control Module I/O Signal > ELECTRICAL SPECIFICATION">

Push button start system
...

Wiring diagram
SECURITY AND LOCKS > Push Button Start SystemWIRING DIAGRAMFor wiring diagrams related to the push button start system (ignition change), refer to the following items.• Keyless access system: ...

Other materials:

Installation
GLASS/WINDOWS/MIRRORS > Rear Gate GlassINSTALLATIONNOTE:Use the markings on the glass to apply adhesive and primer, and to install the dam rubber - rear gate and the spacer - rear gate.(a)Marking for dam rubber - rear gate application (Ag print)(c)Marking for spacer - rear gate application (Ag pr ...

Assembly
DRIVE SHAFT SYSTEM > Front Hub Unit BearingASSEMBLY1. Install the hub unit bearing to the ST securely.Preparation tool:ST: HUB STAND (927080000)2. Using a press, press the new hub bolts (b) until their seating surfaces contact the hub unit bearing (a).NOTE:Use the 12 mm (0.47 in) dia. holes in th ...

Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Manifold Absolute Pressure SensorREMOVAL1. Disconnect the ground cable from battery.2. Disconnect the connector (A) from the manifold absolute pressure sensor, and remove the manifold absolute pressure sensor from intake manifold. ...

© 2016-2025 Copyright www.sucross.com