Subaru Crosstrek Service Manual: Push button start system

Installation

SECURITY AND LOCKS > Push Button Ignition SwitchINSTALLATIONCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBA ...

Electrical specification

SECURITY AND LOCKS > Push Button Start SystemELECTRICAL SPECIFICATIONRefer to “Control Module I/O Signal” of “KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS)” sec ...

Other materials:

Drain filter Specification
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Drain FilterSPECIFICATIONThe leak check valve assembly is a non-disassembled part. Do not remove the drain filter from the leak check valve assembly. Refer to “Leak Check Valve Assembly” for removal and installation procedures. ...

Assembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Drive Pinion Shaft AssemblyASSEMBLY1. Install the plug to drive pinion retainer.NOTE:• Use new O-rings.• Apply CVTF to the O-rings.Tightening torque:22 N·m (2.2 kgf-m, 16.2 ft-lb)2. Using the ST, install the oil seal to drive pinion r ...

Control module i/o signal Electrical specification
BODY CONTROL SYSTEM (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATIONDescriptionTerminal No.Signal (V or ?)NoteIgnition switch ON(Engine OFF)Ignition power supply (rear wiper)A5 ←> Chassis groundLess than 1.5 V > 10 — 13 VIgnition switch OFF > ONBattery power suppl ...