Subaru Crosstrek Service Manual: Relay and fuse

Installation

SECURITY AND LOCKS > ReceiverINSTALLATIONInstall each part in the reverse order of removal.Tightening torque:Receiver assembly: 13 N·m (1.33 kgf-m, 9.6 ft-lb) ...

Inspection

SECURITY AND LOCKS > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.NOTE:If the fuse is blown again, check the system wir ...

Other materials:

Installation
EXTERIOR/INTERIOR TRIM > Cowl PanelINSTALLATIONCAUTION:Before installing the windshield glass and cowl panel, make sure there are no gravel in the installing area.1. Install the cowl panel assembly.CAUTION:If the cowl panel assembly cannot be installed properly, do not hit or set it forcibly. The ...

To arm the system using access key/remote transmitter
1. Close all windows and the moonroof (if equipped). 2. Remove the key from the ignition switch (models without "keyless access with push-button start system")/turn the push-button ignition switch to the "OFF" position (models with "keyless access with push-button start system"). 3. Open ...

Dtc p0123 throttle/pedal position sensor/switch "a" circuit high
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0123 THROTTLE/PEDAL POSITION SENSOR/SWITCH "A" CIRCUIT HIGHDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Improper idling• Engine stall• Poor driving per ...