Subaru Crosstrek Service Manual: Inspection
SECURITY AND LOCKS > Access Key
INSPECTION
1. ACCESS KEY BATTERY
Check the access key battery voltage.
Preparation tool:
Circuit tester
NOTE:
Complete the measurement within 5 seconds because the battery discharges during measurement.
Battery terminal | Inspection conditions | Standard |
(+) — (−) | Connect resistor (A) 47 ? | 2.5 — 3.0 V |
Replace the battery if the inspection result is not within the standard value. (Use CR2032V or equivalent.)
Access key
...
Replacement
SECURITY AND LOCKS > Access KeyREPLACEMENT1. ACCESS KEY REGISTRATIONNOTE:• A maximum of seven access keys can be registered for each individual vehicle.• When replacing or adding an acc ...
Other materials:
Dtc c2541 vehicle dynamics control module vehicle speed sensor
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C2541 VEHICLE DYNAMICS CONTROL MODULE VEHICLE SPEED SENSORTrouble symptom:The steering wheel operation feels heavy.STEPCHECKYESNO1.CHECK DTC.Read the DTC of the VDC system using the S ...
Assembly
CLUTCH SYSTEM > Master CylinderASSEMBLY1. Apply a coat of grease to the contact surfaces of the push rod and piston before installation.Grease:SILICONE GREASE G-40M or equivalent2. Assemble in the reverse order of disassembly.Tightening torque:10 N·m (1.0 kgf-m, 7.4 ft-lb) ...
Specification
WIPER AND WASHER SYSTEMS > General DescriptionSPECIFICATIONFront wiper motorInput12 V — 72 W or lessRear wiper motorInput12 V — 42 W or lessFront washer motorPump typeCentrifugalInput12 V — 60 W or lessRear washer motorPump typeCentrifugalInput12 V — 36 W or less ...
