Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Replacement

SECURITY AND LOCKS > Access Key

REPLACEMENT

1. ACCESS KEY REGISTRATION

NOTE:

A maximum of seven access keys can be registered for each individual vehicle.

When replacing or adding an access key, new registration of the access key is necessary.

When the access key has been newly added, it is registered to the immobilizer system at the same time.

2. CLEARING ACCESS KEY REGISTRATION

Refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” for clearing access key registration.

Inspection
SECURITY AND LOCKS > Access KeyINSPECTION1. ACCESS KEY BATTERYCheck the access key battery voltage.Preparation tool:Circuit testerNOTE:Complete the measurement within 5 seconds because the battery ...

Installation
SECURITY AND LOCKS > Access KeyINSTALLATION1. ACCESS KEY BATTERYInstall each part in the reverse order of removal. ...

Other materials:

Locking and unlocking
Release button Mechanical key While pressing the release button of the access key, take out the mechanical key. Lock or unlock the driver's door with the mechanical key in the procedure described in "Locking and unlocking from the outside" F2-5. NOTE After locking or unlocking, ...

Dtc c0074 master cylinder pressure sensor output
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0074 MASTER CYLINDER PRESSURE SENSOR OUTPUTDTC detecting condition:Defective pressure sensorTrouble symptom:• ABS does not operate.• VDC does not operate.• EyeSight does no ...

Dtc p2270 o2 sensor signal biased/stuck lean bank 1 sensor 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2270 O2 SENSOR SIGNAL BIASED/STUCK LEAN BANK 1 SENSOR 2DTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Me ...

© 2016-2026 Copyright www.sucross.com