Subaru Crosstrek Service Manual: Assembly
CLUTCH SYSTEM > Master Cylinder
ASSEMBLY
1. Apply a coat of grease to the contact surfaces of the push rod and piston before installation.
Grease:
SILICONE GREASE G-40M or equivalent
2. Assemble in the reverse order of disassembly.
Tightening torque:
10 N·m (1.0 kgf-m, 7.4 ft-lb)
Master cylinder
...
Removal
CLUTCH SYSTEM > Master CylinderREMOVALCAUTION:• Be careful not to spill the brake fluid. Brake fluid spilled on the vehicle body will harm the paint surface; wash it off with water and wipe c ...
Other materials:
Replacement of brake pad and lining
The disc brakes have audible wear
indicators on the brake pads. If the brake
pads wear close to their service limit, the
wear indicator makes a very audible
scraping noise when the brake pedal is
applied.
If you hear this scraping noise each time
you apply the brake pedal, have the brak ...
Compression Inspection
MECHANICAL(H4DO) > CompressionINSPECTIONCAUTION:After warming-up, engine becomes very hot. Be careful not to burn yourself during measurement.1. Turn the ignition switch to OFF.2. After warming-up the engine, turn the ignition switch to OFF.3. Make sure that the battery is fully charged.4. Check ...
Certification for immobilizer system
For models with "keyless access
with push-button start system":
Refer to "Certification for keyless access
with push-button start system" 2-19.
For models without "keyless access
with push-button start system":
U.S.-spec. models
FCC ID: MOZRI-38BFH
CAUTION
FCC WARNING
Chang ...
