Subaru Crosstrek Service Manual: Specification
WIPER AND WASHER SYSTEMS > General Description
SPECIFICATION
Front wiper motor | Input | 12 V — 72 W or less |
Rear wiper motor | Input | 12 V — 42 W or less |
Front washer motor | Pump type | Centrifugal |
Input | 12 V — 60 W or less | |
Rear washer motor | Pump type | Centrifugal |
Input | 12 V — 36 W or less |
Caution
WIPER AND WASHER SYSTEMS > General DescriptionCAUTION• Connect the connectors and hoses securely during reassembly.• After reassembly, make sure that the each component or each function ...
Component
WIPER AND WASHER SYSTEMS > General DescriptionCOMPONENT1. FRONT WIPER• Models without EyeSight(1)Motor ASSY - windshield wiper(6)Rubber ASSY - windshield wiper driverTightening torque: N&midd ...
Other materials:
Dtc c1331 rr hold valve
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1331 RR HOLD VALVENOTE:For the diagnostic procedure, refer to “DTC C1362 NORMAL CLOSING VALVE 2”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C1362 NORMAL C ...
Installation
BRAKE > Master CylinderINSTALLATION1. Replace the seal sub assembly for the master cylinder assembly with a new part.CAUTION:Be careful not to install the seal sub assembly in the wrong location.(a)Primary piston(b)Seal sub ASSY(c)Install the seal sub assembly to this surface.2. Install each part ...
Installation
DRIVE SHAFT SYSTEM > Front Hub Unit BearingINSTALLATION1. Place the front brake back plate between the front axle housing and the front hub unit bearing, and tighten the bolt.CAUTION:• Do not get closer the tool which charged magnetism to magnetic encoder.• Be careful not to damage th ...
